Also Peter, if you have the SUB turned on the Main receiver will be on the
left channel and SUB will be on the right channel. You might want to check
your audio level adjustments on your PC. Maybe the left and right levels are
not the same. I use a CONFIG: LIN OUT setting of "nor 010" but you also have
to consider the setting on your PC line-in. And check the back of the K3 to
be sure the line out plug is actually plugged into the line out jack and not
the headphone or speaker jack.
73,
Mike K2MK
RE: [Elecraft] K3 and MixW audio input volume
Greg
Sat, 27 Dec 2008 16:36:05 -0800
Peter,
If you are using the SUB and Main RX at the same time on the same antenna
you will see a 3 dB drop in signal. Try increasing your Line Out setting to
about 10.
73
Greg
AB7R
-----Original Message-----
From:
[hidden email]
[mailto:
[hidden email]]on Behalf Of Peter ZL1PWD
Sent: Saturday, December 27, 2008 4:26 PM
To:
[hidden email]
Subject: [Elecraft] K3 and MixW audio input volume
Seasons greetings from ZL,
I have just upgraded to the 2nd RX and DVR and now get very little signal
showing on the MixW waterfall. Not sure if there is a connection
Using the latest FW and Menu item MIC SEL = LINE IN
Config Item LIN OUT=3
Any thoughts??
TIA and 73
Peter ZL1PWD
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
