K3 mods

classic Classic list List threaded Threaded
4 messages Options
Reply | Threaded
Open this post in threaded view
|

K3 mods

Steven.Zabarnick
Yesterday I overcame my fears :-) and successfully performed the  
following mods on my K3 (S/N 1672):

K3 AF Mod (Line out & speaker)
IF Output Buffer Gain Mod
K3 Extreme Signal RX Protection Mod

But, I was not able to perform the K3 AF Output Mod (two 470 ohm  
resistors on the KIO3 board). I found it impossible to hold the  
resistor in place will soldering to the connector pins. Does anyone  
have any suggestions on techniques for installing these resistors?

Steve N9SZ

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Reply | Threaded
Open this post in threaded view
|

Re: K3 mods

AC7AC
CONTENTS DELETED
The author has deleted this message.
Reply | Threaded
Open this post in threaded view
|

Re: K3 mods

Julian, G4ILO
In reply to this post by Steven.Zabarnick

Steven.Zabarnick wrote
I was not able to perform the K3 AF Output Mod (two 470 ohm  
resistors on the KIO3 board).
I thought they were two 51 ohm resistors (according to the instruction sheet I have here.) Has there been a mod to the mod?
Julian, G4ILO. K2 #392  K3 #222 KX3 #110
* G4ILO's Shack - http://www.g4ilo.com
* KComm - http://www.g4ilo.com/kcomm.html
* KTune - http://www.g4ilo.com/ktune.html
Reply | Threaded
Open this post in threaded view
|

Re: K3 mods

Steven.Zabarnick
In reply to this post by Steven.Zabarnick

Confusingly, there are actually two mods for the K3 with similar names:

The "K3 AF Mod Kit Rev B" which is called the "K3 AF Stage Upgrade" in its
instructions. This one is for the line out and speaker signal pathways, and
involves changing an RF choke and two 51 ohm resistors.

The other mod is the "K3 AF Output Mod Kit, Rev C" and is called the "K3 AF
Amplifier Out Modification" in its instructions. This protects the amps in
case of a short circuit or low impedance load and involves adding two 470
ohm resistors.

Steve N9SZ

Julian G4ILO wrote:

>Steven.Zabarnick wrote:
>>
>> I was not able to perform the K3 AF Output Mod (two 470 ohm
>> resistors on the KIO3 board).
>>
>I thought they were two 51 ohm resistors (according to the instruction
>sheet
>I have here.) Has there been a mod to the mod?


______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html