KAT2 Error code 202

[Paul Huff-3]

My recently installed KAT2 indicates an error code of 202.  The manual says that
error codes for the ATU range from 0 to 199.  Does an error code of 202 indicate
anything?

Thanks in advance for any replies.

73,
Paul - N8XMS

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html

[Don Wilhelm-4]

Paul,

To the best of my knowledge, E202 would be something that the KAT100
might display, but not the KAT2.  Perhaps someone got the firmware
stickers wrong.
I think you should send a note to [hidden email].

73,
Don W3FPR

Paul Huff wrote:

> My recently installed KAT2 indicates an error code of 202.  The manual says that
> error codes for the ATU range from 0 to 199.  Does an error code of 202 indicate
> anything?
>
> Thanks in advance for any replies.
>
> 73,
> Paul - N8XMS
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:[hidden email]
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>
>  

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html

[Ed Lambert-2]

Please note that I also receive this error code on my KAT2 (202).

 

I have successfully gone through all of the testing steps to ensure that
each inductive and capacitive component is available and can be switched
into and out of the circuit. It is my impression, however, that the tuner
unit does not work as well as it did when first installed. Some relatively
simple loads will not tune below, say, 1.8 - 2.0 to 1.

 

Ed Lambert KD3Y

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html

[Paul Huff-3]

In case anyone in the future has the same question, here is a follow-up for the
archive:

According to Gary at Elecraft error code 202 in the KAT2 submenu is a "normal
result code."  So all is well.

73,
Paul - N8XMS

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html