KRX3 is deaf

[K8RS]

Group,
             What haven't I done?  My KRX3 is deaf!

              Here is the story.  After installing the KRX3 and checking to see if all pins and cables were properly seated, I went thru the CONFIG steps and downloaded the latest firmware, FPF and DSP1 & DSP2.  Loading was successful. I activated my 2 SUB Filers (2.8 kHz & 400 Hz. But no audio!.  
               
              What have I missed?  Where should I look next?  I did remove the hard wired W4 jumper.
             
              Roger K8RS K3 #280
_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com

[Augie "Gus" Hansen]

Roger wrote:
> Group,
>              What haven't I done?  My KRX3 is deaf!
>
>               Here is the story.  After installing the KRX3 and checking to see if all pins and cables were properly seated, I went thru the CONFIG steps and downloaded the latest firmware, FPF and DSP1 & DSP2.  Loading was successful. I activated my 2 SUB Filers (2.8 kHz & 400 Hz. But no audio!.  
>                
>               What have I missed?  Where should I look next?  I did remove the hard wired W4 jumper.

Did you enable the KRX3 in the CONFIG menu? You didn't mention this step
in your problem description.

Gus Hansen
KB0YH

_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com

[Brendan Minish]

Check very carefully for dry jointed torrioid leads on the subout board

73
Brendan EI6IZ



On Sat, 2008-08-16 at 13:24 -0400, Roger wrote:
> Group,
>              What haven't I done?  My KRX3 is deaf!
>
>               Here is the story.  After installing the KRX3 and checking to see if all pins and cables were properly seated, I went thru the CONFIG steps and downloaded the latest firmware, FPF and DSP1 & DSP2.  Loading was successful. I activated my 2 SUB Filers (2.8 kHz & 400 Hz. But no audio!.  
>                
>               What have I missed?  Where should I look next?  I did remove the hard wired W4 jumper.
>              
>               Roger K8RS K3 #280

--
Don‘t complain. Nobody will understand. Or care. And certainly don‘t try
to fix the situation yourself. It‘s dangerous. Leave it to a highly
untrained, unqualified, expendable professional.

_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com