KX3-> KXPA100=> KPA500 ... Can it be done?

[David F. Reed-2]

Looking for a little QRO in my alternate station...

I would like to be able to run my KX3 into my KXPA100 amplifier, and
that into my KPA500 amp.

How do I do that?

Thanks
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [hidden email]

[Nr4c]

Yes. Check the manual(s) on KXPA100 and ATU.

Sent from my iPhone
...nr4c. bill

> On Aug 4, 2016, at 1:13 AM, David F. Reed <[hidden email]> wrote:
>
> Looking for a little QRO in my alternate station...
>
> I would like to be able to run my KX3 into my KXPA100 amplifier, and that into my KPA500 amp.
>
> How do I do that?
>
> Thanks
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:[hidden email]
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to [hidden email]

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [hidden email]

[Don Wilhelm]

KX3 to KXPA100 connections are covered well in the KXPA100 manual.  
Download from Elecraft if you do not yet have that manual.

Connecting the KPA500 to the KXPA100 requires a cable from the KXPA100
PA KEY to the KPA500 PA KEY connector.  Of course, you would also
connect the coax, but that should be obvious.

The KPA500 would sense the RF and switch to the correct band - or you
could select the band on the front panel.

73,
Don W3FPR

On 8/4/2016 1:13 AM, 'David F. Reed' [hidden email] [KX3] wrote:
>
> Looking for a little QRO in my alternate station...
>
> I would like to be able to run my KX3 into my KXPA100 amplifier, and
> that into my KPA500 amp.
>
> How do I do that?
>
>

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [hidden email]