|
Well, I don't whisper but I hate to have to shout into a mic to provide
adequate drive. I'm well used to close talking a headset microphone, I use the CM500 all the time on my K3 and there is loads of mic gain in reserve. I have the latest firmware 1.50 in the KX3 and I still find the mic gain is maxed out to give (almost) the recommended ALC action. What is your ALC showing? I have tried mic bias On and OFF with no apparent difference. I set the compression as advised. It sounds fine but I feel there is not enough mic gain.This is the same, as I said, with another headset mic. When I have time I will try my CM500 on the KX3 to see what that does. Anyone else seeing lack of audio drive on their KX3? 73, Denis F5VJC ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[hidden email] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html |
|
Hold down the push down the keyer/mic/pwr knob to where it saws swr/rf
and turn it up and down till its at the mic gain level you need. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[hidden email] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html |
|
In reply to this post by Deni F5VJC
Interested in this thread.. the KX-3 seems a tad low on TX audio gain. I use the same mic/headsets on my K2 and K3 with stacks of audio. Temp fix has been making an audio preamp powered from small battery Tried using the +3.5 volt mic-bias supply but got into all sorts of RF feedback problems. Didn't pursue this, probably could be sorted out. cheers Paul b zl1ajy |
|
what version of the firmware are you running ?
you might try updating to this firmware ftp://ftp.elecraft.com/KX3/firmware/beta ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[hidden email] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html |
|
In reply to this post by Deni F5VJC
KX3 needs a mic with a lot of gain such as the CM500 and other electret mics. My Heil headset with an HC-5 element won't cut it. Most dynamic mics will not either.
|
|
In reply to this post by Deni F5VJC
Can't get enough drive using a Heil HC4 (dynamic) mic which has relatively
low output but no problems with a Heil IC (electret) which has higher output. 73 Geoff G3UCK -----Original Message----- From: F5vjc Sent: Saturday, July 13, 2013 8:58 PM To: Elecraft Reflector Subject: [Elecraft] KX3 Mic gain ? Anyone else seeing lack of audio drive on their KX3? ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[hidden email] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html |
| Free forum by Nabble | Edit this page |
