P3 Utility not connecting

[K5SM]

I am using a Microham Digikeyer to provide the USB to RS232 conversion
and connection to the K3. I have no trouble connecting to the K3 with
either the K3 Utility or K3 EZ or the K3 Memory Editor, but the P3
Utility will not connect. Anyone solve this issue already?

73, Bob K5SM
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html

[M0XDF]

I'm surprised the K3 utility will connect - I understood it did not support the microHam protocol and am not surprised the P3 utility doesn't work either. I purchased a KUSB when I got the K3 for this very reason.
I'm using OSX btw, but that shouldn't come into the equation.
73 de M0XDF, K3 #174, P3 #108
--
I never did a day's work in my life; it was all fun. -Thomas Edison

On 6 Jan 2011, at 14:51, Robert Redmon wrote:

> I am using a Microham Digikeyer to provide the USB to RS232 conversion
> and connection to the K3. I have no trouble connecting to the K3 with
> either the K3 Utility or K3 EZ or the K3 Memory Editor, but the P3
> Utility will not connect. Anyone solve this issue already?

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html

[Chester Alderman]

Bob,

I'm sure you have done this already, but just in case you haven't, your K3
connects to your P3 with your serial cable and the baud rate on the K3  is
fixed between the K3 and P3 at 34800b. Then you connect your PC serial cable
to your P3 and with the P3 you can set the baud rate to what is needed for
your PC. Once you have this set up per the manual instructions, the K3/P3
system will work correct.

Tom - W4BQF


-----Original Message-----
From: [hidden email]
[mailto:[hidden email]] On Behalf Of Robert Redmon
Sent: Thursday, January 06, 2011 9:52 AM
To: [hidden email]
Subject: [Elecraft] P3 Utility not connecting

I am using a Microham Digikeyer to provide the USB to RS232 conversion
and connection to the K3. I have no trouble connecting to the K3 with
either the K3 Utility or K3 EZ or the K3 Memory Editor, but the P3
Utility will not connect. Anyone solve this issue already?

73, Bob K5SM
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html