RX only Ant Select Problem

[Dick-2]

Have RX ant to Aux BNC.  Under config have KRX3 = BNC, according to
manual. Not working. What am I missing in the setup and of config? Front
panel select options?

TIA  Dick

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html

[Don Wilhelm-4]

  Dick,

Do you have the SubRX Aux Antenna connector cable going to the KAT3 or
to the rear panel BNC connector.  The menu is set according to how the
physical installation is wired.
If you have a factory built K3 (and you have not changed it), the cable
to the AUX BNC jack is connected (and you were shipped a TMP cable to
use if you wanted to change it).

73,
Don W3FPR

On 7/11/2011 3:01 PM, Dick wrote:
> Have RX ant to Aux BNC.  Under config have KRX3 = BNC, according to
> manual. Not working. What am I missing in the setup and of config? Front
> panel select options?
>
> TIA  Dick
>
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html

[Mike K2MK]

Hi Dick,

The Sub RX can use either the Main antenna or the Aux antenna (BNC). This selection is in addition to the config that you described. There are 2 ways to view which antenna is being used by the Sub RX. Press SUB from off to on and momentarily read either "MAIN" or "AUX" on the lower line. Another way, when the SUB is already on is to hold the B SET button. MAIN or AUX again displays momentarily.

If the SUB is already on you can change the antenna selection by holding the RX ANT button. Another way to change the selection is to press B SET when the SUB is on and then press the ANT button.

73,
Mike K2MK

Dick wrote

Have RX ant to Aux BNC.  Under config have KRX3 = BNC, according to
manual. Not working. What am I missing in the setup and of config? Front
panel select options?

TIA  Dick