Re: K3 139

[Peter ZL1PWD]

Good afternoon/evening fromZL

We have assembled the k3 and run the initial test stages and have run into a problem.

During the lowpower wattmeter calibration we appear to have no TX output.

Test indicate no RX either.  

Yes we have upgraded to the latest firmware, 01.49

Any suggestions???

Peter ZL1PWD

K3 #0139
_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com

[Matt Zilmer]

Make sure the bit jumper block is in (connects the PA's power).  Also,
make sure your filter(s) are set up properly.  Make sure the filter
you want to use for transmit is enabled, etc.

matt - WA6EGJ
k3 # 24

On Sat, 15 Dec 2007 20:16:32 +1300, you wrote:

>Good afternoon/evening fromZL
>
>We have assembled the k3 and run the initial test stages and have run into a problem.
>
>During the lowpower wattmeter calibration we appear to have no TX output.
>
>Test indicate no RX either.  
>
>Yes we have upgraded to the latest firmware, 01.49
>
>Any suggestions???
>
>Peter ZL1PWD
>
>K3 #0139
>_______________________________________________
>Elecraft mailing list
>Post to: [hidden email]
>You must be a subscriber to post to the list.
>Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft   
>
>Help: http://mailman.qth.net/subscribers.htm
>Elecraft web page: http://www.elecraft.com

_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com

[KK7P]

Hello Peter!

> During the lowpower wattmeter calibration we appear to have no TX output.
> Test indicate no RX either.  

Please direct K3 support questions to "[hidden email]" rather
than the reflector.

Sounds like you may not have the filter enabled, or perhaps one of the
cables between the synth, ref osc and rf board is not completely seated.

k3support may have better suggestions.

73,

Lyle KK7P

_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com