Re: OT(sorta) Setting up KX3 for JT9 ops

[Don Wilhelm]

Jim,

JTx is no different than any other soundcard data mode.
Use DATA A
Set the audio input to the KX3 so you have 4 bars solid on the ALC meter
with the 5th bar flashing.  Once you have the audio level set, leave it
that way.
Control the power output with the POWER knob.
Ignore the advice in the JTx information and on the internet to control
the power with the audio level - that is for non-Elecraft transceivers.

Any differences in the various soundcard data modes will be found in the
software application used, not in the KX3 setup.

73,
Don W3FPR

On 1/19/2017 8:20 AM, James Rodenkirch wrote:
> Anyone operating JT(? If so, anything peculiar for setting up ALC in JT9 versus JT65??
>
> Offline replies "ok."
>
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [hidden email]

[James Bennett]

HI Jim,

I use my KX3 for JT65, JT9, MSK144, and WSPR (in addition to PSK31 and lots of CW) - all the settings are the same on the KX3, other than the power output, which I change to meet band conditions. On WSPR I usually run it at 2 watts; MSK144 on 6 meters it runs 100 watts with the KXPA100.

Jim Bennett /W6JHB
Folsom, CA

> On Jan 19, 2017, at 5:20 AM, James Rodenkirch <[hidden email]> wrote:
>
> Anyone operating JT(? If so, anything peculiar for setting up ALC in JT9 versus JT65??
>
> Offline replies "ok."
>
> Tnx, inn advance, for any info you can proffer - Jim R. K9JWV
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:[hidden email]
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to [hidden email]

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [hidden email]

[Jim Brown-10]

On Thu,1/19/2017 5:20 AM, James Rodenkirch wrote:
> Anyone operating JT(?

Yes.

> If so, anything peculiar for setting up ALC in JT9 versus JT65??

No,

73, jim K9YC

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [hidden email]