I don't use FlDigi, but do use a variant of WinPSK. Set up a regular split using
the "B" VFO by double tapping A->B to copy everything to B. Turn on "Split" and
dial in the desired offset using the "B" VFO. If you need to check your TX freq,
hold the "REV" key.
On 9/13/2014 7:02 PM, Ron Schwartz wrote:
> This may be a simple question, but how does FLDigi run wide (>2.5Khz) split with the K3?. The waterfall does not allow the transmit frequency to be locked further than the sound card bandwidth from the receive frequency. FYI, I do not have the K3 sub-receiver installed. I presume some variation of the RIT/XIT controls, the VFO B control, and/or FLRig needs to be used, rather than using the transmit ‘Lk’ on the waterfall.
>
> Thanks, Ron
> K2RAS
> ______________________________________________________________
> Elecraft mailing list
> Home:
http://mailman.qth.net/mailman/listinfo/elecraft> Help:
http://mailman.qth.net/mmfaq.htm> Post: mailto:
[hidden email]
>
> This list hosted by:
http://www.qsl.net> Please help support this email list:
http://www.qsl.net/donate.html> Message delivered to
[hidden email]
>
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.htmlMessage delivered to
[hidden email]
Locked
